ducoterra
ef9104c796
All checks were successful
Reese's Arch Toolbox / build-and-push-arch-toolbox (push) Successful in 14s
26 lines
983 B
Markdown
26 lines
983 B
Markdown
# Bambu P1S Notes
|
|
|
|
## Bambu P1S
|
|
|
|
### WiFi
|
|
|
|
If you want to set up WiFi without logging in follow this:
|
|
|
|
<https://wiki.bambulab.com/en/p1/manual/p1-sd-card-network-configuration-guide>
|
|
|
|
### Connecting via LAN mode
|
|
|
|
- Make sure you open 1990 and 2021 (tcp + udp) in your firewall application.
|
|
|
|
### Troubleshooting
|
|
|
|
#### Under Extruding
|
|
|
|
I've had an issue where prints will look "clumpy" or "rough". This was resolved after a complete
|
|
hotend swap. I did some testing on the bad nozzle before replacing it and found it could still
|
|
extrude decently but I had to raise the temperature 50-60°C above 220° to get the plastic flowing
|
|
well. I don't think the ceramic heater was broken since the nozzle was clearly heating just fine.
|
|
This leads me to believe the thermistor went bad or became disconnected from the nozzle somehow. My
|
|
guess is Bambu didn't use enough thermal compound at the factory and it became dry and cracked,
|
|
creating a layer of air between the thermistor and the nozzle.
|