Workstation/octopi.md

OctoPi Setup

GCode Snippers

After Pause

{% if pause_position.x is not none %}
; relative XYZE
G91
M83

; retract filament of 0.8 mm up, move Z slightly upwards and 
G1 Z+5 E-0.8 F4500

; absolute XYZE
M82
G90

; move to a safe rest position, adjust as necessary
G1 X0 Y0
{% endif %}

After Resume

{% if pause_position.x is not none %}
; relative extruder
M83

; prime nozzle
G1 E-0.8 F4500
G1 E0.8 F4500
G1 E0.8 F4500

; absolute E
M82

; absolute XYZ
G90

; reset E
G92 E{{ pause_position.e }}

; WARNING!!! - use M83 or M82(extruder absolute mode) according what your slicer generates
M83 ; extruder relative mode

; move back to pause position XYZ
G1 X{{ pause_position.x }} Y{{ pause_position.y }} Z{{ pause_position.z }} F4500

; reset to feed rate before pause if available
{% if pause_position.f is not none %}G1 F{{ pause_position.f }}{% endif %}
{% endif %}

Plugins

Bed Visualizer

M140 S60 ; starting by heating the bed for nominal mesh accuracy
M117 Homing all axes ; send message to printer display
G28      ; home all axes
M420 S0  ; Turning off bed leveling while probing, if firmware is set
         ; to restore after G28
M117 Heating the bed ; send message to printer display
M190 S60 ; waiting until the bed is fully warmed up
M300 S1000 P500 ; chirp to indicate bed mesh levels is initializing
M117 Creating the bed mesh levels ; send message to printer display
M155 S30 ; reduce temperature reporting rate to reduce output pollution
@BEDLEVELVISUALIZER	; tell the plugin to watch for reported mesh
G29 T	   ; run bilinear probing
M155 S3  ; reset temperature reporting
M140 S0 ; cooling down the bed
M500 ; store mesh in EEPROM
M300 S440 P200 ; make calibration completed tones
M300 S660 P250
M300 S880 P300
M117 Bed mesh levels completed ; send message to printer display